Our Products - 4WD Recovery Products - R&R Beadbreaker

Fed up with changing tyres?

The ground breaking R&R BEADBREAKER that won't break your back...
or your pocket!

The R&R Beadbreaker and tyre refitting tool not only breaks the bead but also assists in replacing the tyre on the rim.

Because no rubber hammers damage the bead of the tyre, you can refit TUBELESS tyres without the need for a tube. And because it's lightweight, you can work on a table or on your vehicle's tailgate (out of the mud and sand!). This helps keep the tyre and rim clean to ensure a perfect reseal.

Most importantly, the R&R Beadbreaker helps you avoid back strain by removing the need to bend and twist at the same time.

To Break The Bead...

The R&R Beadbreaker is placed across the wheel, with the noseplate resting between the tyre and the rim and the rear plate resting on the outer edge of the rim. The "T" bar on the base of the threaded rod is located under the edge of the centre hole of the wheel. The barrel nut is then screwed down using a 19mm ring spanner, forcing the nose plate to separate the bead of the tyre from the rim. Simple!  

To Replace A Tyre...

The rear plate of the R&R Beadbreaker has been inverted into a hook, which is then placed under the tyre and locked over the edge of the rim. The upright bolt prevents the tyre from sliding forward.

The "T" bar is then placed under the edge of the centre hole of the wheel and the barrel nut is screwed down until the underside of the nose plate is on the rim, securing the tyre in a fixed working position on the rim.